re: Defragmenter always stops at 66% Tuesday, June 10, 2008 at 8:45 am Windows Me Annoyances Discussion Forum Posted by C K (6528 messages posted) That's an old drive with a bad history. I'm surprised it is still running. It's probably having media failure as was consistent with it's history. I would back up any data you want to save and replace it. OTH, Spinrite 6 may be able to do a temporery repair if it is losing data (but don't count on it). Then it is time to get your data off of it and replace it. Problem is, will your motherboard properly support the large drives made today?? On Monday, June 9, 2008 at 5:44 pm, Kiremerwa-Kato Simon wrote: >It is made by Quantum Fireball--lct.; >lct 10 3.5" Series; >Power requirements: 5/12V===600/900mA; >Made in Singapore; >It uses FAT; >The total capacity of disk is 9.52GB; >Unused space is 2.94GB; >Free space is 6.57GB. Does this information help you diagnose the problem? Waiting >for your response. Written in response to: re: Defragmenter always stops at 66% (Kiremerwa-Kato Simon: Monday, June 9, 2008 at 5:44 pm) There are presently no replies to this message. All messages in this thread [show all] Defragmenter always stops at 66% (Kiremerwa-Kato Simon: Tue, Jun 3, 2008, 10:39 pm) re: Defragmenter always stops at 66% (Keith Stanier: Wed, Jun 4, 2008, 4:12 am) re: Defragmenter always stops at 66% (Kiremerwa-Kato Simon: Thu, Jun 5, 2008, 2:06 am) re: Defragmenter always stops at 66% (Keith Stanier: Thu, Jun 5, 2008, 4:27 am) re: Defragmenter always stops at 66% (C K: Thu, Jun 5, 2008, 10:11 am) re: Defragmenter always stops at 66% (Kiremerwa-Kato Simon: Mon, Jun 9, 2008, 5:44 pm) re: Defragmenter always stops at 66% (C K: Tue, Jun 10, 2008, 8:45 am) Reply or follow-up to this message Search this forum Start a new thread on a different subject Report abuse of the forum Return to the Windows Me Discussion Forum