re: Why Do I Get "Bad Command or File name" message? Tuesday, November 3, 2009 at 5:42 am Windows Me Annoyances Discussion Forum Posted by Keith Stanier (1248 messages posted) mali wrote: |i trid that but now it say's invalid drive specification Well as I've said it depends if the path is set. As the A:\ prompt just type in cd c:\windows\command and enter, thats providing windows in installed on C: drive. Then just type in scanreg you can forget the restore bit that will be shown inside when its running. If you get an error incorrect filename or command then scanreg.exe isn't in that folder where it should be. Written in response to: re: Why Do I Get "Bad Command or File name" message? (mali: Monday, November 2, 2009 at 6:35 pm) There are presently no replies to this message. All messages in this thread [show all] Why Do I Get "Bad Command or File name" message? (Dell: Tue, May 5, 2009, 8:45 pm) re: Why Do I Get "Bad Command or File name" message? (C K: Tue, May 5, 2009, 10:49 pm) re: Why Do I Get "Bad Command or File name" message? (Keith Stanier: Wed, May 6, 2009, 4:39 am) re: Why Do I Get "Bad Command or File name" message? (Dell: Wed, May 6, 2009, 2:37 pm) re: Why Do I Get "Bad Command or File name" message? (mali: Mon, Nov 2, 2009, 6:35 pm) re: Why Do I Get "Bad Command or File name" message? (Keith Stanier: Tue, Nov 3, 2009, 5:42 am) re: Why Do I Get "Bad Command or File name" message? (Dell: Wed, May 6, 2009, 6:46 pm) re: Why Do I Get "Bad Command or File name" message? (Keith Stanier: Thu, May 7, 2009, 2:14 pm) Reply or follow-up to this message Search this forum Start a new thread on a different subject Report abuse of the forum Return to the Windows Me Discussion Forum